Hello. I bought a kit for cruise control for my A2 from China, I have mounted from the lever on the steering wheel and onto the control unit in the floor according to the explanation of YouTube, but I am left with a black cable that I find no good explanation for, Think there is a cable that will give power to the control on the steering wheel. Are someone here who can give me some help with this. I am aware I have to program the control unit when it is fully connected with VCDS Software.
Cruise control
- Thread starter stemyhre
- Start date
depronman
A2OC Donor
You should have 4 wires from the stalk to the ecu pins
From memory stalk pins 2,3,4&7,5 go to the pins on the ecu.
Stalk pin 6 is the 12v ignition live that can go to any ignition live typically the brake light switch
The ecu pins vary depending on diesel, 1.4 petrol, 1.6 petrol
Cheers Paul
Sent from my iPhone using Tapatalk
From memory stalk pins 2,3,4&7,5 go to the pins on the ecu.
Stalk pin 6 is the 12v ignition live that can go to any ignition live typically the brake light switch
The ecu pins vary depending on diesel, 1.4 petrol, 1.6 petrol
Cheers Paul
Sent from my iPhone using Tapatalk
2work
Well Known Member
Evening,
If the aftermarket kit you’ve purchased is this very item then I can confirm that the black wire with no pin attached is for a terminal 15 (switched/ignition) feed which can be picked up from Pin #2 on the brake pedal switch (test with a multimeter first just incase there is a slight difference in pinout between LHD and RHD):
I had to fitting of these into an A2 a couple of weeks ago. The pins were not correct by any means and the loom length was certainly not for a RHD but you might just about get away in your LHD A2.
Here’s a rather useful link that’ll help out with which wire goes to where at the ECU:
www.a2oc.net
Kind regards,
Tom
If the aftermarket kit you’ve purchased is this very item then I can confirm that the black wire with no pin attached is for a terminal 15 (switched/ignition) feed which can be picked up from Pin #2 on the brake pedal switch (test with a multimeter first just incase there is a slight difference in pinout between LHD and RHD):
Turn Signal Cruise Control Lever w/ Cable Kit 8L0953513J Fit For Audi A2 A6 TT | eBay
MPN: 8L0953513J 1J1 970 011 F. fit for Audi A2 2000-2005. fit for Audi A6 S6 C5 1998-2005. fit for VW New Beetle 1998-2005. fit for Audi TT 1999-2006. fit for Audi A3 S3 1997-2003. fit for Audi A4 B5 1999-2000.
www.ebay.co.uk
I had to fitting of these into an A2 a couple of weeks ago. The pins were not correct by any means and the loom length was certainly not for a RHD but you might just about get away in your LHD A2.
Here’s a rather useful link that’ll help out with which wire goes to where at the ECU:
Cruise control for 1.4 16v AUA
Hello all. Can any one give me the part number for cruise control shifter ,and a diagram for 1.4 16v AUA petrol engine?
www.a2oc.net
Kind regards,
Tom
Last edited:
