Speedo needle stuck💤💤

[Sad]

How do I remove the Speedo cowling which is blocking the Speedo needle?

 

[A2Steve]

Far easier to show with photos, but here goes

- 2 x trox screws on underside of cowling
- lift cowling off by moving it slightly back and fore and pulling up.
- this will expose 1 torx at the back holding the speedo in place
- remove the flexible sleeve that goes between the speedo and the steering cowling. That will expose a further 2 torx screws

once the above is done the speedo will lift out of its space. You can then release the elctrical plugs and take it out of the car.

The clocks themselves can be taken apart by releasing the clips all the way around to pop the front off.

 

[Sad]

Thanks for that. The needle is stuck cause the plastic face had warped inward thus blocking the free movement of needle. Can't see the 2 Torx heads however. Will look closer. Cheers

 

[kp 115]

Thanks for that. The needle is stuck cause the plastic face had warped inward thus blocking the free movement of needle. Can't see the 2 Torx heads however. Will look closer. Cheers

Upwards