Tdi replacing of engine mount

Snottie

Member
Hi, replaced my dog bone gearbox mount and it removed half of the engine bucking if you know what I mean, I now want to do the passenger side engine mount, anyone done this, how is it best done?
 
Good work - the dogbone mount makes a huge difference. I had that and the nearside mount done at the same time by Tony at A2 Cars.
 
Well does anyone know how to change the passenger side engine mount? Do I have to suspend the engine or can I use a jack from below?
 
I would say do it properly and use an engine crane. If you prop it up from below you risk damaging the aluminium structures in the sump.
 
Is that not how you replace the dogbone gearbox mount?

I have done it, looking for guidance for passenger side engine mount!
 
Last edited:
Mustang Owner's instructions were for replacing the passenger side mount. Removing the 'dog bone' allows the engine unit to be dropped /raised without restriction you can work on the mount.

Cheers Spike
 
Back
Top