Audi thru'n'thru
A2OC Donor
I'm replacing a broken front spring with a new spring and shocker but I'm having major problems getting the strut back into the hub - I'm only getting it in about 15mm then it's really stuck.
I've checked various threads on the subject but nobody describes the best way to get the strut back into the hub.
I've tried locating the top bearings first and jacking under the hub; and trying with the top bearing not in place. I've had a go with the old 'cold chisel' to try and widen the gap but I'm wary of getting too extreme and damaging the hub. Any suggestions would be very much appreciated.... thanks, Peter
I've checked various threads on the subject but nobody describes the best way to get the strut back into the hub.
I've tried locating the top bearings first and jacking under the hub; and trying with the top bearing not in place. I've had a go with the old 'cold chisel' to try and widen the gap but I'm wary of getting too extreme and damaging the hub. Any suggestions would be very much appreciated.... thanks, Peter