depronman
A2OC Donor
Hi all
I've recently bought a VAG KKL cable 409.1 and it came with VAG-COM
It all loaded up OK under Window 10 64bit (pleasant surprise) but needed to be run in compatibility mode
I connected to My A2 (1.4 petrol 2001MY), I can connect to lots of modules perfectly fine, but trying to connect to the engine module is proving difficult. I get a error message regarding syncing Baud rate see below -
Chassis Type: 8Z - Audi A2
Scan: 01,02,03,08,15,16,17,18,37,45,46,56,57,75,76,77
-------------------------------------------------------------------------------
Address 01: Engine Labels: None
Controller: p öp öp ö
VCID: 62B7298BFD57
Note: Can't Synch Baud Rate
-------------------------------------------------------------------------------
Address 03: ABS Brakes Labels: None
Controller: 8Z0 907 379 B
Component: ESP 20 CAN V015
Coding: 10758
Shop #: WSC 00000
VCID: 47E1D81F76B5
No fault code found.
I've scanned the engine module many times, some times it will pull up random characters in the 'Controller' field, other times it will be blank
Any ideas what is wrong ?
I can connect to the ABS / CCCU / Audio etc without a problem
Best regards,
Paul
I've recently bought a VAG KKL cable 409.1 and it came with VAG-COM
It all loaded up OK under Window 10 64bit (pleasant surprise) but needed to be run in compatibility mode
I connected to My A2 (1.4 petrol 2001MY), I can connect to lots of modules perfectly fine, but trying to connect to the engine module is proving difficult. I get a error message regarding syncing Baud rate see below -
Chassis Type: 8Z - Audi A2
Scan: 01,02,03,08,15,16,17,18,37,45,46,56,57,75,76,77
-------------------------------------------------------------------------------
Address 01: Engine Labels: None
Controller: p öp öp ö
VCID: 62B7298BFD57
Note: Can't Synch Baud Rate
-------------------------------------------------------------------------------
Address 03: ABS Brakes Labels: None
Controller: 8Z0 907 379 B
Component: ESP 20 CAN V015
Coding: 10758
Shop #: WSC 00000
VCID: 47E1D81F76B5
No fault code found.
I've scanned the engine module many times, some times it will pull up random characters in the 'Controller' field, other times it will be blank
Any ideas what is wrong ?
I can connect to the ABS / CCCU / Audio etc without a problem
Best regards,
Paul