Super quick OpenSky Reset Question…

jonbad

Member
I know, I know… there are +1,000 threads all about OpenSky and believe me, I've read nearly all of them (ugh :confused:).

However, I have not yet come across anyone mentioning the following (quote from SSP_378 Service Training Manual):

The open sky control unit must be reinitialised after work on the roof or after replacing the drive motor in order to memorise the respective limit positions. The motor can be removed and installed in any position.

Please can somebody state the reinitialisation process? I have access to VagCom and ElsaWin. The only thing I have read in ElsaWin (under Sliding roof > Removing and installing sunroof panel) is:

- After closing roof, press and hold button for operating sunroof again for approx. 10 seconds.
- This initialises the motor and pushes the locking hook into the correct position.
 
Back
Top