Yes thats for wake up current, but I need constant high current for the lights. Like 10 amps or more.Best bet is to tap off the back of the headlamp connector (or fogs if fitted) - not necessarily a constant 12V feed, but it can be if you have your lights switched on. Watch the current draw too - don't want fuses blowing all the time.
I looked these also, location is great.I used the fan power wire going into the control box. It is in the right position too right in front and in the middle.
But I can’t temember if it is constant or not.
But it is a nice thick wire to feed off.
Steve B
I installed 100w led bar. Dont want to loose original high beam's.what are you trying to put on? You'll need more than 10A for Xenon, I have 15A fuses for mine... but you could also just disconnect the standard high beam (kaukovalo, musta / valkoinen kaapeli) and use that to power the new lights?
I'd personally also rather put a new cable through, it's easy if you use the same hole as for the bonnet release.
- Bret