G
Guest 4123
Guest
The problem started when the starter motor refused to turn over which I eventually found out was due to the clutch needing adjustment! For the last two weeks or so I've been trying to carry out a basic setting on the gearbox, which includes adjusting the clutch. I would get to the point where Block 14, field 1 should change from SEARCHNG to IGN.OFF after about 15 secs, but it would not. No error codes would be generated in the process.
Eventually, yesterday after checking a query from Ross Tech, I attempted the same procedure again and at last it worked. I had made no changes since the last attempt but it was somewhat warmer yesterday than when the previous attempts were made. The only conclusion I can come to is that the ambient temperature is significant. Field 4 does show the transmission temperature. Or is it just a dodgy connection somewhere?
RAB
Eventually, yesterday after checking a query from Ross Tech, I attempted the same procedure again and at last it worked. I had made no changes since the last attempt but it was somewhat warmer yesterday than when the previous attempts were made. The only conclusion I can come to is that the ambient temperature is significant. Field 4 does show the transmission temperature. Or is it just a dodgy connection somewhere?
RAB