Sylvester
Member
Hi, I've been sorting out MAP sensor fault codes possible issues, and after cleaning the vent hoses, I've removed the TB to see how dirty it is, but upon assembling, I can't do adaptation.
It's clicking back and forth at first, but few seconds later, the plate is just shaking/vibrating in the same position for 2-3 seconds. Then it opens up a bit more and the same cycle happens again in a loop, keep showing with ADP runs, ADP ok, ADP error...
Along with the MAP fault code I used to get TB 1 sensor or TB 2 sensor codes, but after deleting them when cleaning the vent hoses, those didn't come back. Can those be the reasons the adaptation doesn't work? Do I need a new Throttle Body?
Also due the issues, I haven't been driving for 2-3 weeks and the battery voltage dropped to 11.60v. What if it goes below the 11.5v, which is the lowest requirement for TB adaptation, doesn't it mean it won't work with e.g.: 11.0v? Thanks
It's clicking back and forth at first, but few seconds later, the plate is just shaking/vibrating in the same position for 2-3 seconds. Then it opens up a bit more and the same cycle happens again in a loop, keep showing with ADP runs, ADP ok, ADP error...
Along with the MAP fault code I used to get TB 1 sensor or TB 2 sensor codes, but after deleting them when cleaning the vent hoses, those didn't come back. Can those be the reasons the adaptation doesn't work? Do I need a new Throttle Body?
Also due the issues, I haven't been driving for 2-3 weeks and the battery voltage dropped to 11.60v. What if it goes below the 11.5v, which is the lowest requirement for TB adaptation, doesn't it mean it won't work with e.g.: 11.0v? Thanks