I did provided a refurb service at one point in time but it was a poor take up and I repurposed the tooling I made to hold the centre cap in my lathe for something else
Basically I mounted the centre cap in the lathe and used a scrapper to remove the old lacquer and worming then buffed the ally ring to a brushed steel look using scotchbrite
The applied 4 coats of clear 2K lacquer to seal the ally ring
It was quite time consuming to be honest and at £30 for a set of four I expected much better take up
I only did a set of my own and a set for timmus and one other for a member
Paul
Sent from my iPhone using Tapatalk