Audi A2 from Sweden

After half an hour driving in different conditions I managed to provoke the beep and Christmas tree. It happened on first gear at very slow speed. No limp mode this time. I could just drive on with all lights on the dash board ligting. I made a vcds scan without turning the engine off.

17961 - Barometric / Manifold Pressure Signals: Implausible Correlation

P1553 - 35-10 - - - Intermittent

It doesn't say anything to me. When the engine is jerking I could imagine the pressure signal from the manifold is pretty chaotic.

Also make sure your oil cap is on tight on the engine itself, and check for any air leaks from hoses. Also check the evap purge valve


Sent from my iPhone using Tapatalk
 
Also make sure your oil cap is on tight on the engine itself, and check for any air leaks from hoses. Also check the evap purge valve


Sent from my iPhone using Tapatalk
I have an oil leak from where the oil level stick hose attaches to the oil sump. I heard from someone else it can cause an air leak that affects how the engine is running. Do you think this might be a problem?
I have already replaced the purge valve and the rubber hose from the oil trap.
 
these engines are very sensative to air leaks, so yes could be
I always slow test them to see if any leaks and were from
very common from the inlet manifold

Paul
 
I have an oil leak from where the oil level stick hose attaches to the oil sump. I heard from someone else it can cause an air leak that affects how the engine is running. Do you think this might be a problem?
I have already replaced the purge valve and the rubber hose from the oil trap.

Yes, also look for any air leaks from vacuum pipes, even the oil cap being loose will cause issues


Sent from my iPhone using Tapatalk
 
Here come some updates what I've been doing on my Audi A2 lately.
I have changed following parts on my BBY engine.
Intake and EGR pipe from an BBZ engine and a Renault throttle body.

Parts
Intake 036129711FD
Renault Throttle body 408238827002
EGR intake pipe 036131521BF
Black silicon hoose 2,5 inch length 67 mm


It works very good and I will remap the ecu this spring.
And it looks original in the engine compartment.

2021-02-10-15-18-14.jpg


2021-02-10-15-20-02.jpg
 
Back
Top