itsmeagain
Past Member
Where is the crank case sensor on a 2004 1.4 petrol A2 , and how easy or difficult is it to change
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Crank case sensor
- Thread starter itsmeagain
- Start date
Hi
Under the engine, very difficult to change. This is a quote from another post
"I had a look at changing the sensor myself and managed to trace the sensor from the where it clips into the harness to where the sensor is mounted. The wiring clips in under the driver-side inlet manifold and as is possible to get to. The actual sensor is mounted on the crankshaft on the clutch side and is not visible and neither will you be able to feel it. Elsawin is not that useful.
I took the car to my "local" garage in Birmingham (I live in London hence the 150 mile roound trip). Up on a ramp, remove the driver-side driveshaft from the gearbox to allow a x-shaped plate to be removed that is mounted onto the bottom of the inlet manifold. With the plate removed he could follow the wire into the gearbox housing. There is a rubber bung to stop water ingress (remove this) and you can get an allen-key onto the sensor. Replacement is the reverse."
Lähetetty minun Lenovo A7600-F laitteesta Tapatalkilla