I dropped this piece while changing the clutch and I don't know where it goes.

ibizagti

ibizagti

A2OC Donor
Hello, yesterday I lowered the gearbox of my A2 BHC to change the clutch and I saw that it had a metal bushing that I don't know where it goes.
Can someone help me know where it should be mounted?

On the other hand, how do you center the clutch? I think the crankshaft hole is a little bigger and the usual tools don't work

Thanks from Spain!
 
CrispyEdd said:
Can you add a photo of the bushing?
You should centre the centre using a centering tool?
Click to expand...
:D yes of course. I forgot to add the photos. It is metallic.
 

Attachments

  • PXL_20231126_071119844.jpg
    PXL_20231126_071119844.jpg
    2.3 MB · Views: 62
  • PXL_20231126_071117591.jpg
    PXL_20231126_071117591.jpg
    2.7 MB · Views: 65
ibizagti said:
Hello, yesterday I lowered the gearbox of my A2 BHC to change the clutch and I saw that it had a metal bushing that I don't know where it goes.
Can someone help me know where it should be mounted?

On the other hand, how do you center the clutch? I think the crankshaft hole is a little bigger and the usual tools don't work

Thanks from Spain!
Click to expand...
If you haven't got a centring tool you can make one with a piece of wooden Dowling and wrap tape around to make it a snug fit onto the center bearing and one for the clutch. I've done it with a pencil & tape in the past with no issues.
 
I found it over the gearbox like the second photo. The plastic pieces are not a problem. But the metallic one i dont know where It was. The only holes that has the same diameter are the other two photos... And i think that is not the correct position
 

Attachments

  • PXL_20231126_121427475.jpg
    PXL_20231126_121427475.jpg
    2.7 MB · Views: 50
  • PXL_20231126_121121223.jpg
    PXL_20231126_121121223.jpg
    3.6 MB · Views: 43
  • PXL_20231126_121237715.jpg
    PXL_20231126_121237715.jpg
    3 MB · Views: 45
the metal part looks like one of the three selector cable mounts that have a rubber piece with the metal fitting through the middles, and clutch centre tool you can find a perfect fitting long reach socket that should get you close enough while refitting the pressure plate ,
 
To centre the clutch plate with out a clutch centering tool(cheap)I have found a socket. The same size as clutch centre! Put the extension into and centred the clutch plate by eye! Usually works for me!
 
You must log in or register to reply here.
Back
Top