Hello everybody,
I would like to get some help as I can't find solution for my problem. So, here is my story.
I have just bought AUDI A2 1.2tdi. It has 140000km on the dash. Everything works fine, BUT the car can not be started while gear lever is on STOP position, it can be started only on N. Now I will tell what steps I have already made for solving that problem.
--- Firstly, I checked hydraulic fluid level according to all instructions. It is ok.
--- Brake lamps are working fine when brake pedal pushed.
--- Hydraulic pump begins to work once I open the door and works for about 30s.
--- It can be made only 2-3 gear shifts (while engine is not running) and then pump starts again.
--- I made basic setting with no problems. Voltage from clutch sensor was about 0.6V, I adjusted it to about 1.9V. Then made other two steps, basic setting and creep point. (It had another one problem before basic settings. While on ECO mode engine shuts down and then putting the foot away from brake pedal it does not start, you need to start it on N with a key, but the basic setting "cured" that problem, but still does not starts on STOP)
So I have few questions and I think there are some people that could help me:
--- Is it possible that pressure accumulator would help (I already have new one, but haven't installed yet) ?
--- When car is parked on STOP and engine is shut off, should clutch be engaged? I mean, when trying to pull the car it won't move, because it will be on 1 gear. Am I right? Because when my car is left on STOP i can push it or pull it like it is on N. So my clutch is not engaged?
--- When doing basic setting you need to loosen gear actuator nut. But I do not know exactly when should I tighten it? After gear actuator makes some shift or when?
--- Would like to get some advises to "heal" my car that it would start on STOP.
Thank you if you read it
I would like to get some help as I can't find solution for my problem. So, here is my story.
I have just bought AUDI A2 1.2tdi. It has 140000km on the dash. Everything works fine, BUT the car can not be started while gear lever is on STOP position, it can be started only on N. Now I will tell what steps I have already made for solving that problem.
--- Firstly, I checked hydraulic fluid level according to all instructions. It is ok.
--- Brake lamps are working fine when brake pedal pushed.
--- Hydraulic pump begins to work once I open the door and works for about 30s.
--- It can be made only 2-3 gear shifts (while engine is not running) and then pump starts again.
--- I made basic setting with no problems. Voltage from clutch sensor was about 0.6V, I adjusted it to about 1.9V. Then made other two steps, basic setting and creep point. (It had another one problem before basic settings. While on ECO mode engine shuts down and then putting the foot away from brake pedal it does not start, you need to start it on N with a key, but the basic setting "cured" that problem, but still does not starts on STOP)
So I have few questions and I think there are some people that could help me:
--- Is it possible that pressure accumulator would help (I already have new one, but haven't installed yet) ?
--- When car is parked on STOP and engine is shut off, should clutch be engaged? I mean, when trying to pull the car it won't move, because it will be on 1 gear. Am I right? Because when my car is left on STOP i can push it or pull it like it is on N. So my clutch is not engaged?
--- When doing basic setting you need to loosen gear actuator nut. But I do not know exactly when should I tighten it? After gear actuator makes some shift or when?
--- Would like to get some advises to "heal" my car that it would start on STOP.
Thank you if you read it
Last edited: