The lights on the light switch dial not working

Crgwal

A2OC Donor
Scotland
Hello,

The actual lights that show up on the switch it's self all work except the top three. For off, low beam, high beam.

I noticed this as when I switched the car on the other day they were on for a few seconds then went off and on a few times until staying off.

Is this simply just a bad light switch unit?

Thanks,
Craig
 
I understand that's quite a common thing, one of mine does it too - a bad solder joint on the circuit for the LEDs behind those three icons. It's possible to get in there and re-flow with care, I think I remember seeing some advice about this on the forum.
 
That's the badger - many thanks Spike. I had forgotten it was a 'replace the circuit board' job rather than soldering. That gives me hope that I can do the same for one of my hard touch ones if the LEDs in one of my worn soft-touch spares are working reliably.
 
Back
Top