Trolley jack / axle stands...

[Brabazon]

I need to raise the front to look at my ARB, - can anyone advise where the jacking points are for using a trolley jack and where the axle stands should be positioned? I'm sure I've seen a pic on here in the past but can't seem to find it...

Thanks, Jon

 

[Skipton01]

At the front, place the trolley jack at the reinforced area in line with the place where the supplied jack would go. If you get your head under the car, look along the line of the tube that accepts the supplied jack and you'll see a round plastic bung, about 50mm is diameter - this is in the middle of the reinforced area.

Axel stands can be placed under the point where the wishbone enters the subframe (a large silver circular casting).

Cheers,

Mike

 

[spike]

Hi Jon
The pics in this thread by Alan uk may also help - http://www.a2oc.net/forum/showthread.php?t=4600&highlight=jacking+points

Cheers Spike

 

[Brabazon]

Thanks Mike. I thought those looked the most obvious but just wanted confirmation.

There's no rubber bung in mine though, just a hole... Must have fallen out or something...

Cheers, Jon


I saw those pics Spike, thanks, but they only seem to show the rear. I thought I had seen pics of the front somewhere... Maybe on a pdf I downloaded or something...