Votex Style Bodykits

Hi Iain

I sold what I had left to A2Steve so I am sure he will sell you a set (he is not a dear guy so the price should be good to.o but I don’t know for sure.

Steve B
 
2work said:
Morning Iain,

Might be worth reading this thread to see what is remaining regards Votex Jacking Point covers.

I understand the last complete set have been sold.

Hopefully someone else will start to reproduce them.

Kind regards,

Tom
Click to expand...
Hi Tom

A2Steve has my remaining stock so can provide a set or two (and some singles)

Steve B
 
Birchall said:
Hi Tom

A2Steve has my remaining stock so can provide a set or two (and some singles)

Steve B
Click to expand...

Thanks Steve,

A2Steve sold the last complete set last night. Only singles remaining. Hopefully Paul can get his 3D printer on the go to continue your hard work on these.

Where did you get with the reproducing full Votex kit. Do you have mould for these yet.

Kind regards,

Tom
 
Has he not got singles fir each of the four covers. There were enough fir at least two or three full sets by adding the singles together.

I was unable to get mould s made for the body kit. Just the mould fir the rear tailgate spoiler. I have advertised the mould and one of the sample tailgate spoilers on the marketplace here.

Steve B
 
Hi Steve,

A2Steve reports the following on a Market Place thread:

‘All sets now spoken for, only singles left

Only have 3 x rear passenger and
4 x front drivers left’

Shame about the bodykit mould but hopefully I get a positive reply regards the Spoiler reproduction soon.

Kind regards,

Tom
 
Paul,

I hope you can get access as it would be a shame for the work Steve out in to just stop.

Good luck.

Kind regards,

Tom
 
Sarge has the printer and the files and he is now going to start looking at producing these again. I have been advertising them for a LONG time and at Steve B prices. I have advertised them on eBay and mentioned it on the German A2 Owners forum.

It just seems that now I have stopped there seems a lot of interest in them.

Steve B
 
Last edited:
Birchall said:
Almost correct.

I doesn't fit as it is but some members have managed to trim the original spoiler down to make the Votex spoiler fit.

So it is possible.

You always have the option of swapping the tail gate from a non FSI, if you don't want to cut the spoiler?

Steve B
Click to expand...

Would like to have this confirmed: the original Votex rear spoiler will fit all 1.4’s petrol or diesel regardless, but will not fit 1.2 or 1.6?
 
My son has spent a lot of time and money working to get the moulds sorted. He now has 5 available but people think that they are too expensive at around £380. But the money has had to spend to get them right means he has no choice or he will be losing all of his money and time.
Steve B
 
Birchall said:
My son has spent a lot of time and money working to get the moulds sorted. He now has 5 available but people think that they are too expensive at around £380. But the money has had to spend to get them right means he has no choice or he will be losing all of his money and time.
Steve B
Click to expand...

Which part is £380 ?
 
Just the rear spoiler nobody would mould the side skirts and nobody would do the front and back skirts properly.

sorry
Steve B
 
You must log in or register to reply here.
Back
Top