So this has bugged me for a while now....
Drivers door sounds like it's open when driving around, but it's not.
From the outside, it looks slightly off around the b pillar rubbers, but the gap where it joins the wing is the same as the passenger side.
From inside, the fit/sit lines all look good and fine till you get level with the window door card and the b pillar. At which point I can't easily get my sausage fingers in there all the way down.
I've already tried the door catch hook thing, as I previously had a VW Passat which let those come loose for fun. However, moving it inwards just resulted in the door not shutting properly at all, so that's not it although that is the logical check.
All the door rubbers are there too - it's not that there's some soft rubber missing, it's an actual physical air gap.
Any suggestions oh wise ones?
Drivers door sounds like it's open when driving around, but it's not.
From the outside, it looks slightly off around the b pillar rubbers, but the gap where it joins the wing is the same as the passenger side.
From inside, the fit/sit lines all look good and fine till you get level with the window door card and the b pillar. At which point I can't easily get my sausage fingers in there all the way down.
I've already tried the door catch hook thing, as I previously had a VW Passat which let those come loose for fun. However, moving it inwards just resulted in the door not shutting properly at all, so that's not it although that is the logical check.
All the door rubbers are there too - it's not that there's some soft rubber missing, it's an actual physical air gap.
Any suggestions oh wise ones?