Handbrake

Anyone got any ideas on handbrake adjustment i.e. how to access and adjust?

Thanks.

Matt

It has an automatic adjust but you should look here: http://web.archive.org/web/20031011215759/http://www.audi-a2.co.uk/guide5.doc
With these images you should be able to find the screws/nuts.

Thanks for that, very useful, will give it a go tonight....see what plastic clips I can break

Hi

This is from Audi workshop manual, if all you want to do is adjust the number of clicks when you pull on the handbrake. You don't need to remove the whole handbrake cover assembly just the bit facing the rear seats.

Hope this makes sense

Jonathan



Servicing rear wheel brake, drum brake
Adjusting handbrake
The handbrake must be adjusted after charging/adjusting the service brake system. The service brake system must be fully functional.

The handbrake cables must not be under tension.

Resetting is only required after replacing the handbrake cables, the brake carrier or brake pads.

‒ Release handbrake.
‒ Remove the rear storage compartment.
‒ Firmly press brake pedal several times.
‒ Pull handbrake lever 4 notches.



‒ → Tighten adjusting nut -arrow- until both wheels are difficult to turn by hand.
‒ Release handbrake and check, whether both wheels can spin freely. If necessary, screw back adjusting nut slightly.

It is unnecessary to adjust the handbrake after readjustment owing to the automatic adjustment of the rear brake.

It just so happens my MOT is due and my Handbrake needs adjusting
will let you know how i get on thanks for Info ....