i dont know if it is on the jobcard, and i have to say that i havent seen it myself, allthough the lower part of the bootlid is made of plastic so i doubt it would have dented, i will look into it for you if i remember lol.
heres some more progress pics
new panel is drilled and countersunk along the bootlid edge and the upper part of the lamp panel, due to not being able to get to both sides of the panel with the rivvet tool.
then the same is done with the joining panel on the car so the panel fits flush and so the rivvets sit as flush as possible
then i had to measure and drill holes (panels dont come with any pre drilled holes) where the bracket for the wheel arches go, as these have riv nuts in(picture shows riv nuts in place)
cleaned up scotched and etch primed
prepped and primed new panel
loadsa bond
plates bonded in ready for welding