Any tips on how to rectify this please good A2OC folks
On removing the air filter housing cap one of the screws was slightly tight to remove - once it came out it had plastic wrapped around the thread which I guess has come from the filter housing it screws into.
Now when I try to tighten it up it is simply spinning. The other screw nips up fine but the housing now has a gap of at least 5mm at the side where the screw doesn't nip up.
Any fix suggestions?
On removing the air filter housing cap one of the screws was slightly tight to remove - once it came out it had plastic wrapped around the thread which I guess has come from the filter housing it screws into.
Now when I try to tighten it up it is simply spinning. The other screw nips up fine but the housing now has a gap of at least 5mm at the side where the screw doesn't nip up.
Any fix suggestions?