Early wiper arm plastic cover

Not answering to your question, but to raise this thread upwards, I’ll update my cover situation.

After the last reply, I printed second version with a SLA printer. Since the resin used in the SLA printer is sensitive to UV, I’m still intending to make the final version from ASA later.

The result after sanding and painting with UV resistant spray paints ended up quite presentable. The cover has been solidly in place for 9 months now and seems to work as intended.

I’ll update the situation again with the recommended settings when I get the final version printed.
 

Attachments

  • IMG_1029.jpeg
    IMG_1029.jpeg
    1.4 MB · Views: 21
  • IMG_1031.jpeg
    IMG_1031.jpeg
    1.5 MB · Views: 19
RantA2 said:
Not answering to your question, but to raise this thread upwards, I’ll update my cover situation.

After the last reply, I printed second version with a SLA printer. Since the resin used in the SLA printer is sensitive to UV, I’m still intending to make the final version from ASA later.

The result after sanding and painting with UV resistant spray paints ended up quite presentable. The cover has been solidly in place for 9 months now and seems to work as intended.

I’ll update the situation again with the recommended settings when I get the final version printed.
Click to expand...
Looks really good!! Just need someone to print a few and cost it out then...
 
You must log in or register to reply here.
Back
Top