diggerinthedark
Member
so, ive written off the idea of getting a whole new key-software needed is too expensive and so is the part (i could only find the blade for 59.99). but i would like to get a new remote half (39.99), can i replace just that? and can i program that with VCDS without needing my SKC? also, which part of the key has the clip which holds the two parts together? mine is broken so it always comes in half. would be nice if i could take the leccy tape off it.
and, if i did end up getting a new blade because i find it cheaper or my budget increases, could i not very carefully just swap the immobiliser chip over and avoid all the hassle anyway?
and, if i did end up getting a new blade because i find it cheaper or my budget increases, could i not very carefully just swap the immobiliser chip over and avoid all the hassle anyway?
Last edited: