Water Drain Seal?

sinlessUK

sinlessUK

Member
Does anybody have a P/N for item 'A' in the picture below, mines missing :(

a2-5371.png
 
Last edited:
Try a search on parts.org - i,m not sure exactly what that is - "chb" would know.
 
Last edited:
Is it a threaded drain bung? Would a standard bung not do - eg the type found with air beds and the like.
 
I think thats one of the two rubber capped water dranage "tubes" that push on underneath the bonnet Spike. I think you are right about a better picture. The original one appears to show a key shaped type item that fits close to the bulkhead ?. Is it a small drain tube that pushes into the black plastic lower scuttle which catches water off the windscreen. ?. Is there small hole under the scuttle tray "sinless". ?. Have a look at this - a water drainage tube shown as 2F - part number 8Z0819307C'
http://www.partsbase.org/audi/audi-...er-ducts-air-hoses-and-vents-water-deflector/
Ta
Dave
:)
 
Last edited:
Appreciate everyone looking. It's a smaller version of the ones attached to the underside of the bonnet that channels the water away. Its the one on the passenger side of the bulkhead shown here

XWL5KOVZU3Q6.jpg
 
I think that part number 8Z0819307C is what you need - it doesnt show a part number for the rubber tube that fits onto it. They will not be very expensive to order from a dealer or a breaker. I would ring them and enquire about the rubber tube that goes with it.
Ta
Dave
:)
 
Last edited:
Special edition said:
I think that part number 8Z0819307C is what you need - it doesnt show a part number for the rubber tube that fits onto it. They will not be very expensive to order from a dealer. I would ring them and enquire about the rubber tube that goes with it.
Ta
Dave
:)
Click to expand...

Think your right Dave. I have the tube but no rubber flappy bit on the end. Its a small version of the ones on the underside on the bonnet. Shall ask Audi tomorrow.

Many Thanks Guys!
 
Last edited:
The picture in the first post is a good likeness. Is it perhaps part of B and is not available as a separate item. I also don't believe it is anything to do with drainage - it's too short. 8Z0819307C is perhaps the drainage tube for the cover at the base of the windscreen. It looks to me as a simple non-return valve - air can only pass out of it and not into it.

RAB
 
Last edited by a moderator:
I agree Rab that the first diagram resembles a form of "tap" release valve but the photo looks very similar to the drain tube part.
Ta
Dave
:)
 
The drain tube for the moulding at the base of the windscreen is about 18mm OD, much larger than what A would be connected to, in a different position and it drains into the wheel arch. If A was a drain it would drain to a lower level, not drip water over the rear of the engine. A has a flat end, so that air cannot enter it.

RAB
 
I think you are right and i am wrong - the one I found could be the tube that drains out through the wheelarch - thankyou for pointing this out. I will continue my search for a part number.
Ta
Dave
:)
 
Last edited:
You must log in or register to reply here.
Back
Top