For the few members who own a small lathe, this innovative lathe tool may be of interest. I've always struggled to grind conventional lathe tools as the normal cutting angles used on 'big' lathes don't always seem to give a good finish, even with very light cuts.
This 'diamond' tool holder by Eccentric Engineering uses 1/4" square (or round) bits which are ground on a simple jig. Although quite expensive, roughing and finishing are so much better, I think it's worth every penny
Cheers Spike
This 'diamond' tool holder by Eccentric Engineering uses 1/4" square (or round) bits which are ground on a simple jig. Although quite expensive, roughing and finishing are so much better, I think it's worth every penny
Cheers Spike