That’s what I use. They seemed pretty good but I didn’t remember to do a before and after comparison.
Sent from my iPhone using Tapatalk
View attachment 60779Today I dropped my A2 at Stealth Racing for some few little jobs ?
Hopefully the 2 hours journey will pay off...
I think I wrapped pretty much the whole interior ?I would hate to be the mechanic working on your car with that pristine cream interior
What are you having done?View attachment 60779Today I dropped my A2 at Stealth Racing for some few little jobs ?
Hopefully the 2 hours journey will pay off...
Replacing pressed steel wishbones with cast, possibly shocks/ springs replacement and a good pampering to the engine, hopefully restoring the original power output. Basically a deluxe service ☺What are you having done?
Cool, “replacing pressed steel wishbones with cast” is something will need doing at some point on my car. When I changed my gearbox oil there I noticed some surface corrosion however what I didn’t check was what corrosion was inside. The next time I jack it up with wheels off I’ll inspect properly.Replacing pressed steel wishbones with cast, possibly shocks/ springs replacement and a good pampering to the engine, hopefully restoring the original power output. Basically a deluxe service ☺
I will attempt to do the same as Sally’s car is in the garage for exactly the same today only along with full bilstein suspension change the tdi meyle control arms were about £67 each ..I will see if Andy can apportion labour coasts might not be that easy but will give you an idea ..?Cool, “replacing pressed steel wishbones with cast” is something will need doing at some point on my car. When I changed my gearbox oil there I noticed some surface corrosion however what I didn’t check was what corrosion was inside. The next time I jack it up with wheels off I’ll inspect properly.
If possible when yours is done could you ask what it costs for just that to be done and send me a PM as I’d like to know what the ball park figure would be unless it’s itemised.
Thanks in advanced.
Sure, no probs. Few horror stories recently where wishbones failed suddenly due to internal rust so I decided to tackle this now rather than driving while exercising my sphincter ?Cool, “replacing pressed steel wishbones with cast” is something will need doing at some point on my car. When I changed my gearbox oil there I noticed some surface corrosion however what I didn’t check was what corrosion was inside. The next time I jack it up with wheels off I’ll inspect properly.
If possible when yours is done could you ask what it costs for just that to be done and send me a PM as I’d like to know what the ball park figure would be unless it’s itemised.
Thanks in advanced.
Brilliant thank you, it will be useful to compare prices and then depending on condition either wait or get it done. That is the only mechanical thing that I think will need attention having inspected the condition of nearly everything else which is fine.I will attempt to do the same as Sally is is in the garage for exactly the same today only along with full bilstein suspension change the tdi meyle control arms were about £67 each ..I will see if Andy can apportion labour coasts might not be that easy but will give you an idea ..