Hello,
I have a bumble bee (Audi A2 Colour Storm Imola Yellow 2004), and I have a problem with a crank shaft sensor.
Few years ago I had this error, replaced sensor and problem was solved, but about a year later error returned, and after sensor replacement problem is still there, replaced another sensor from different manufacturer - did not help.
No problem when starting engine, error show up after ~3000 rpm and show "check engine" and another indicators is on, and rpm goes down, but engine still works.
Interesting fact: if sensor bolt is not tightened no error engine runs smoothly, if tightened then error over 3k rpm.
What is done :
Replaced G28 sensor x2
Replaced G40 (cam shaft) sensor
Replaced G28 wire and connector (Shielded cable 3wire)
Please help.
I have a bumble bee (Audi A2 Colour Storm Imola Yellow 2004), and I have a problem with a crank shaft sensor.
Few years ago I had this error, replaced sensor and problem was solved, but about a year later error returned, and after sensor replacement problem is still there, replaced another sensor from different manufacturer - did not help.
No problem when starting engine, error show up after ~3000 rpm and show "check engine" and another indicators is on, and rpm goes down, but engine still works.
Interesting fact: if sensor bolt is not tightened no error engine runs smoothly, if tightened then error over 3k rpm.
What is done :
Replaced G28 sensor x2
Replaced G40 (cam shaft) sensor
Replaced G28 wire and connector (Shielded cable 3wire)
Please help.