The original text is as follows
1. Vor dem ersten Gebrauch, bitte auf Fabrikeinstellung zurücksetzen. Einstellung wie unten gezeigt: AUTO--0--AUTO--0--AUTO Positions- und Abblendlicht blinken, Zurücksetzung ist beendet.
2. Die Stromquelle der Leaving Home Funktion ist das Positionslicht, deshalb ersetzen Sie diese Lampe bitte mit einer 20A, falls Sie eine Xenon Lampe benutzen oder Ihre NSW viel Strom brauchen.
3. Das rote Kabel ist der Leaving Home Funktion Jumper und sollte mit dem positiven „+“ des Blinklichtes verbunden werden. (Bitte nicht mit der normalen Spannung verbinden, da sonst die Nebelleuchten und das Positionslicht bei Dunkelheit ständig leuchten)
4. Bitte stellen Sie sicher, dass der Sensor an einer gut beleuchteten Stelle angebracht ist.
5. Das Modul speichert die Lichtbedingungen wenn Sie das Abblendlicht einschalten. Wenn es dunkel ist, benutzen Sie es so: AUTO-- Vorderlicht --AUTO-- Vorderlicht —AUTO, danach leuchtet das Positions- und Vorderlicht einmal auf und speichert die aktuellen Lichtgegebenheiten der Umgebung. Wenn die aktuelle Lichthelligkeit höher als die ist, bei der der Sensor das Vorderlicht anschaltet, schaltet sich das Vorderlicht nicht von alleine ein. Falls die aktuellen Lichtbedingungen allerdings innerhalb der gespeicherten Lichtbedingungen sind, wird das Vorderlicht automatisch eingeschaltet.
The translation from Google is nearly good enough but some phrases are confusing, Google states it as
1. Before first use, please reset to factory setting. Setting as shown below: AUTO - 0 - AUTO - 0 - AUTO position and low beam flashing, reset is complete.
2. The power source of the Leaving Home function is the position light, so you replace this lamp with a 20A please if you are using a xenon lamp or NSW need a lot of power.
3. The red wire is the Leaving Home function jumper and should be connected to the positive "+" of the flashing light. (Please do not connect the normal voltage, otherwise the fog lights and the position light in the dark glow constantly)
4. Please make sure the sensor is mounted in a well-lighted area.
5. The module stores the light conditions when you turn on the low beam. When it is dark, use it like this: auto- motive headlight headlight --AUTO-- -AUTO, then the position and front light flashes once and stores the current lighting conditions of the environment. If the current light brightness is higher than that at which the sensor turns on the light front, the front light does not turn on by itself. If the current lighting conditions, however, are within the stored light conditions, the front light is turned on automatically.
Cheers
Steve B