audifan
A2OC Donor
Something just was not sitting right with me regarding the torque settings for these bolts..
Here is the manual page just down from your illustration and gives a table with the following torques..
M10 bolts are 40Nm and no mention of plus "X" degrees
The same torque is also mentioned in the table higher up on that page. Where did you find the torque of 60Nm plus 90 degrees?
Information from this page...
Here is the manual page just down from your illustration and gives a table with the following torques..
Component | Nm | |
Bolts/nuts | M6 | 9 |
M7 | 15 | |
M8 | 20 | |
M10 | 40 | |
M12 | 65 | |
Except for the following: | ||
Battery plus (+) cable to starter | 16 | |
Earth wire to gearbox | 22 | |
Bracket for wiring harness to coolant hose/pipe connection | 10 | |
Drive shaft heat shield to cylinder block | 33 | |
Air pipe to: | Turbocharger | 8 |
Sump | 8 | |
Body | 8 | |
Engine cover panel to bracket | 5.5 |
M10 bolts are 40Nm and no mention of plus "X" degrees
The same torque is also mentioned in the table higher up on that page. Where did you find the torque of 60Nm plus 90 degrees?
Information from this page...
Audi Workshop Service and Repair Manuals > A2 > Power unit | 3-cylinder TDI unit injector engine (1.4 ltr. 2-valve), mechanics | Engine assy,cylinder block,crankcase | Installing engine
A2 > Audi Workshop Service and Repair Manuals > Power unit | 3-cylinder TDI unit injector engine (1.4 ltr. 2-valve), mechanics | Engine assy,cylinder block,crankcase | Installing engine
workshop-manuals.com