clubsport,
Are you requiring anything specific? I can't remember seeing a PDF detailing an oil change, but the princaple is the same as any oil change.
1. Run engine until warm
2. Turn off engine and remove under tray
3. Remove bonnet
4. Remove drain plug (sump nut)
5. Remove oil filter
6. Once old old has drained fit new sump plug
7. Fit new oil filter
8. Add about 4lts of new correct spec oil
9. Start engine and run on tick-over until warm
10. Stop engine and check for oil leaks
11. Let engine rest for 5 minutes
12. Check oil level on dipstick and add as necessary (500mls at a time)
13 Re-fit under-tray
14. Re-fit bonnet
15. Time for a brew
For the TDi AMF engine the following applies
36mm 6 point (Hex) Socket required to remove the oil filter cap, tightning torque is 25Nm
Sump plug thightning torque is 30Nm
If you need anything else just ask.
Cheers
Jeff