the grim reeper
A2OC Donor
Hi All
When i first start the car either first thing in the morning or 8 hours or so later when leaving work, the car starts fine (nearly first turn) but then runs very lumpy like its on 2 cylinders (ABS light and yellow triangle warning lights on dash) after about 10>15 minutes of just letting it tickover to warm up. Turn it off and start again it runs fine no lights no hesitation drives normal. Its done this for a couple of days now just in the mornings but now its doing this after work too. Checked the glow pugs today 2 where faulty so swapped all 3 but no joy, we did notice that there was no voltage coming down the cables but was unsure if this because the engine was warm and so wasn't showing voltage??. Any clues where to look next Fuse, relay or is this run from a module??? any help much appreciated.
Phil
When i first start the car either first thing in the morning or 8 hours or so later when leaving work, the car starts fine (nearly first turn) but then runs very lumpy like its on 2 cylinders (ABS light and yellow triangle warning lights on dash) after about 10>15 minutes of just letting it tickover to warm up. Turn it off and start again it runs fine no lights no hesitation drives normal. Its done this for a couple of days now just in the mornings but now its doing this after work too. Checked the glow pugs today 2 where faulty so swapped all 3 but no joy, we did notice that there was no voltage coming down the cables but was unsure if this because the engine was warm and so wasn't showing voltage??. Any clues where to look next Fuse, relay or is this run from a module??? any help much appreciated.
Phil