jollyjohnny
Member
Hi everybody, I lifted the following text from another post. I have the exact same problem and codes, except the speedo still works. I've seen a few posts that mention fuse 38 and an 80amp fuse located -where? Further in the post it says it was fixed by replacing a fuse but doesn't say which one. Any help or advice would be greatly appreciated.
Regards
John
Original post:-https://www.a2oc.net/community/index.php?threads/speedo-power-steering-stopped-working-at-the-same-time.29512/
Hi to everybody and forgive me for my spelling mistakes
I've tried to find similar topic to my problems, but they are all single problem, so I think this is "something new"
Few days ago my power steering has stopped working, speed gauge (mileage meter also) while rpm meter works. I have noticed that fuel gauge vary when I'm increasing the speed. Diagnostic shows the speed (if that's important)
I have two DTC codes
01309 - Electrohydraulic steering, control unit
- No communication
- Permanent
00562 - Oil sensor
- Short circuit to positive or open circuit
- Permanent
They both came at the same time. On the dashboard I have oil sensor displayed and a wheel displayed.
We had a very strong rain in a past few days and I think I squashed something on the car (is it possible?) because the road was very wet
Do you have any suggestion where I should start checking? Are these wires connected (for power steering and oil level sensor) somehow?
I'm checked oil level in the power steering can and it's OK. Maybe some fuse? I couldn't identify any broken, but I will recheck
Regards
John
Original post:-https://www.a2oc.net/community/index.php?threads/speedo-power-steering-stopped-working-at-the-same-time.29512/
Hi to everybody and forgive me for my spelling mistakes
I've tried to find similar topic to my problems, but they are all single problem, so I think this is "something new"
Few days ago my power steering has stopped working, speed gauge (mileage meter also) while rpm meter works. I have noticed that fuel gauge vary when I'm increasing the speed. Diagnostic shows the speed (if that's important)
I have two DTC codes
01309 - Electrohydraulic steering, control unit
- No communication
- Permanent
00562 - Oil sensor
- Short circuit to positive or open circuit
- Permanent
They both came at the same time. On the dashboard I have oil sensor displayed and a wheel displayed.
We had a very strong rain in a past few days and I think I squashed something on the car (is it possible?) because the road was very wet
Do you have any suggestion where I should start checking? Are these wires connected (for power steering and oil level sensor) somehow?
I'm checked oil level in the power steering can and it's OK. Maybe some fuse? I couldn't identify any broken, but I will recheck