Will check shocks when I've got it stripped down...wonder if I've got any spa....yes I have spares lol.Remember to replace the top hat bushing when you do the springs. Shocks OK?
Springs are all intact...hence me thinking they my have sagged a tad with age...like us all!!!!Could the springs have broken?
Looks really quite clean inside!Some more pics
All duly noted and will be corrected tomorrow(yes I am slightly OCD too, but thought the centre puller is more visible when I put it like that...the tyre hunks that i have found in the past are usually about 13years out of date(give or take a few years),and the positive cover is actually sat atthe bottom of the battery tray...will fish it out tomorrow...nice to see you are paying attention to the photos though ?.Really is coming back to life nice. A few point from your boot picture. You are missing the plastic flap that sits over the battery positive connections which is even more important as you have the spare wheel carrier fitted, the tyre sealant is missing although you have the fold flat spare installed and lastly the wheel center cap removal clip is facing horizontal instead of the hook end pointing downwards. All anorak stuff I know.
Its aftermarket tyre gunk...probably out of date too...it will be thrown!!!!Ok what is the half filled jar sitting in the tow hitch storage area?
If I were to keep it, yes I agree it needs some new shoes...but that may be something for the new owner to personalise...pepper pots or fat 5's...the decision is theirs!Looks really quite clean inside!
EDIT: The outside looks lovey too, it’s a set of wheels away from being really tidy all-round.
Pepperpots would suit Castle Red I reckon - they’d be a nice contrast for a darker colour
When you replaced the manifold, did you do the adaptation with vcds?New springs fitted today, still sits slightly low, bit not as bad as before...only down side is the eml has come back on again today...will scan it again tomorrow...the love of A2's eh?
No mate, wasn't aware it needed it till now...think I may need to visit my pal with the ross tech cable...do you happen to know the route to adapt it?When you replaced the manifold, did you do the adaptation with vcds?
Mac.
Any ideas on the way to do it pal?That is exactly what is required.