Two problems with AAC and alarm

[mtl]

Finally found some time to check the car with VCDS 9.12. Found few fault codes and did some research, but would appreciate if somebody could help me with them:
Address 45: Inter. Monitor Labels: 8E0-951-177.lbl
Part No: 8N8 951 177
Component: Innenraumueberw. D03
Coding: 00001
Shop #: WSC 00000
1 Fault Found:
65535 - Internal Control Module Memory Error
00-00 - -
_______________________________________
Address 46: Central Conv. Labels: None
Part No: 8Z0 959 433 K
Component: Komfortgerát T2D 0614
Coding: 06730
Shop #: WSC 00384
Part No: 8Z1959801
Component: Trsteuer.FS BRM 0001
Part No: 8Z1959802
Component: Trsteuer.BF BRM 0001
Part No: 8Z0959801A
Component: Trsteuer.HL BRM 0001
Part No: 8Z0959802A
Component: Trsteuer.HR BRM 0001
2 Faults Found:
01616 - Signal Wire to Interior Monitor
79-00 - Please Check Fault Codes
01616 - Signal Wire to Interior Monitor
49-10 - No Communications - Intermittent
According to Humps post (http://www.a2oc.net/forum/showthread.php?7482-Glass-breakage-sensor&highlight=01616 ) 01616 means that two interior sensors mounted near the rear mirror are problematic. Am I on the right track? This would probably be the same fault as error 65535 shows? Is it possible to bridge them, so I could check if the problem is in sensor or in the wiring? Probably this is also why the alarm does not set on? Where is the wiring connected to?
Anyway, previous owner had anti-theft GPS service installed, so maybe during installation/deinstallation of this, the wiring was damaged.

-------------------------------------------------------------------------------
Address 17: Instruments Labels: 8Z0-920-xxx-17.lbl
Part No: 8Z0 920 900 G
Component: W1-KOMBIINSTR. VDO D13
Coding: 05142
Shop #: WSC 00384
2 Faults Found:
01304 - Radio
49-00 - No Communications
01320 - Control Module for Climatronic (J255)
49-10 - No Communications - Intermittent
Should I worry about these two errors or is this normal just no communication?

-------------------------------------------------------------------------------
Address 08: Auto HVAC Labels: None
Part No: 8Z0 820 043
Component: A2-KLIMAVOLLAUTOMAT 0406
3 Faults Found:
00710 - Defroster Flap Positioning Motor (V107)
41-10 - Blocked or No Voltage - Intermittent
00818 - Sensor for Evaporator Outlet Temperature (G263)
30-00 - Open or Short to Plus
01317 - Control Module in Instrument Cluster (J285)
49-10 - No Communications - Intermittent
Where this Evaporator sensor is located, so I could check it?
Are 00710 and 01317 something I should worry about?

Thx in advance for any help.

 

[spike]

If you have not already done so, start by checking the fault codes here - http://wiki.ross-tech.com/wiki/index.php/Category:Fault_Codes
Or here - http://www.a2oc.net/forum/showthread.php?t=13367&highlight=fault+codes
The G263 sensor is behind the dash which means dash removal on UK cars. Think its 'just' possible to access the sensor on LHD cars without doing this. Try a search for G263.
Just found this thread which may help - http://www.a2oc.net/forum/showthread.php?t=8991&highlight=G263+evaporator&page=2

Cheers Spike

 

[mtl]

Thx for help regarding G263 sensor. I have already checked the fault codes with ross-tech, but there is just a short description, so not very usefull to me.