The manual says to remove the blower, unplug connector and then remove a screw.
From the drawing, it looks like it's got a series of fins (cooling?) on it.
Cheers,
Mike
Are you able to tell me the part ID of the J126 control unit?
Many thanks.
The manual says to remove the blower, unplug connector and then remove a screw.
From the drawing, it looks like it's got a series of fins (cooling?) on it.
Cheers,
Mike
I am not sure if you have tried to move the fan by hand...
With the glovebox out set the CC to recirc - this opens the bottom flap below the fan.
switch the ignition off - stick you hand through the opening and grab fan - it should move freely... if not the fan needs to be removed (cleaned and freed up if you can) or a replacement (which I did as I didn't have the time to clean and free ours)