Had a go at setting up my convenience module today, unfortunately the codes don't seem to work for me as in the earlier posts.
Originally had 06859 - locks conventionally, no speed lock, no 2 stage unlock
Following the code map posted earlier
Tried a number of combinations;
Enable (bit6) 32 only - CL via speed lock works, except boot
Enable (bit5&6) 32 + 16 As above, no boot lock
Enable (bit5) 16 only - no CL via speed or boot lock
So adding 32 to the total gives CL via speed but cant get the boot to lock in any combination
Couldn't figure out what (bit1) adding 1 did
May have missed it but I dont think (bit2) adding 2 did anything either
Only way I could find to enable the 2 stage unlocking was to Add 4 (bit3)
Enable (bit11) 1024 - blip on locking, nothing on unlocking (guess this is normal - didnt bother with this in the end)
So
06859 - conventional operation
06892 - CL via speed, no boot, no 2 stage unlock
06906 - CL via speed, no boot, no 2 stage unlock
06907 - CL via speed, no boot, no 2 stage unlock
06908 - CL via speed, no boot, 2 stage unlock works
06911 - CL via speed, no boot, 2 stage unlock works no obvious direrence from 06908
07930 - Pip when locking otherwise same as 6906
Tried a few others but no better result, left it on 06911 for now as most of it is there... (4096+2048+512+128+64+32+16+8+4+2+1=6911)
Convenience module is Komfortgerat TBD 1210 1.6FSi 04 plate.
Anyone got any sugestions? Must be a slightly different code configuration on this module but I cant figure it...
Regards