Here is the "Chenglish" instructions for a current advert
Function Description
1. Automatic switch lights --- the switch placed in the AUTO file, when the ambient brightness is lower than the set brightness, will automatically open the wide light and low beam; when the ambient brightness is higher than the set brightness will automatically Close the wide and low beam lights.
2. Automatic switch before the fog lamp --- front fog lights with the light automatically open and close.
3. Manual switch front fog lights --- switch knob in the AUTO gear can manually switch the front and rear fog lights Note: The original car headlamp switch in the AUTO file can not pull out the knob before and after the fog lamp, change the switch can AUTO file Switch front and rear fog lights.
4. Delayed bright light - ambient brightness is less than the set brightness, the key power open after 10 seconds to open the low beam, in the 10 seconds to start the engine can protect the battery.
5. After the launch of the bright light --- ambient brightness is less than the set brightness, the key power within 10 seconds to launch the car, low beam will open within 3 seconds to facilitate emergency driving at night.
6. Tunnel mode --- tunnel mode is convenient to tunnel and more high-speed road driving, the mode is turned on, will detect the light intensity suddenly dimmed quickly open the low beam and wide light, you can effectively solve the tunnel feel slow Problem; the drawback is that when driving in the urban area will open the bridge near the beam and show wide lights, it is recommended only in the day when running high-speed tunnel mode.
Function settings
1. Set the wide light --- the light switch on the wide light file for more than 3 seconds, twist to the low light stalls stay less than 1 second, and then twist back to the wide light file, the lights flash twice that set the success , Do not flash that the current brightness is too bright, set the failure.
2. Set the low beam --- the light switch placed in the low light file for more than 3 seconds, twist to show wide lamp stalls stay less than 1 second, and then twist back to the low light file, the light flashes three times that set the success, Does not flash that the current brightness is too bright, set the failure.
3. Set the front fog light --- the light switch placed in the wide light file for more than 3 seconds, twisted to the ATUO stalls stay less than 1 second, and then twist back to the wide light file, the lights flash once said fog lights near Light automatically open, flash twice that the front fog light does not open with the low light
4. Set the lighting delay --- the light switch on the O file for 3 seconds or more, twist to the AUTO file to stay less than 1 second, and then twist back to the O file, the indicator light once to detect the light is less than the set value of 0.5 seconds (Normal mode), flashing three times to indicate that the light is less than the set value of 5 seconds after the light (delay mode), the light is turned on (the tunnel mode), flash twice to detect the light is less than the set value of 3 seconds after the light (normal mode)
Note: The tunnel mode is suitable for high-speed road running tunnel, and the tunnel will light up immediately. Ordinary mode to adapt to running fast city road, usually within 3 seconds through the bridge hole, to avoid the day off the bridge hole lights. The delay mode is adapted to run the slow urban road, usually within 5 seconds through the bridge hole, to avoid the daytime bridge hole lights.
5. Switch fog lamp --- switch in the AUTO file, when the wide light or low beam open case, the headlamp switch twisted to show wide stalls stay less than 1 second, and then twist back to AUTO file, you can manually open Front fog lights, and then repeat the operation once to close the front fog lights.
6. Switch fog lights --- switch in the AUTO file, when the wide light or low beam open case, the headlamp switch twisted to O lights stalls stay less than 1 second, and then twist back to AUTO file, you can manually open After the fog lights, and then repeat the operation once you can turn off the fog lights.
Can not believe in this day and age that the translations are as bad as an episode of 'Allo 'Allo.....