Are we getting a how to on this one? Looks really good!
Steve will be able to give you a better how to, but for now, here goes....
Remove the door panel (four screws)
Separate all four panels
•top panel
•back panel
•armrest
•door pocket
Remove existing fabric to get down to the fibreglass.
Clean each panel with rubbing alcohol or equivalent (Do this well, all sides, back and crevasses)
Choose your fabric wisely!! We initially chose pvc leather and it was a nightmare! If you are going to use a fabric, choose the thinnest fabric you can; anything thick is a b****r to get around the corners and rounded parts.
We used self adhesive vinyl wrap in the end.
Cut the fabric to its approximate size, leaving a 3-4cm overhang for the concave parts and to make sure you have enough to secure it at the back of the panel.
Heat up the fabric and panel using a hair dryer (on hottest setting), or a heat gun.
Peel off the vinyl backing sheet to half way and press down. Once it’s secure, remove the other half and press down.
Now, using the hairdryer, it’s just down to patience, perseverance and pained fingers....use the heat and either your fingers or a squeegee to press out the air bubbles - working from the centre to the outer edges.
Don’t be quick to cut it, just keep stretching it around the corners in small sections, until it’s flat and crease free. Good luck lol!
Once you’re happy with the finish, piece the four sections back together and secure using kitchen cabinet screws.
Finally, it’s time refit the door panel on the door panel itself. I didn’t do this part so can’t offer any instructions, but it sounded like Steve banged it, a lot!
Maybe
@A2Steve will do a video for you?
If you’re going to try it, good luck! It’s a pig of a job ?