Fault 19586/P3130/012592 - EGR System: Regulation Range Exceeded

[zago]

Hi everyone,

Does anyone has this fault and could share his experience ?Audi a2 1.4 tdi, BHC.

 

[Riba]

Everyone had it at some point. Search the forum, there is a lot of info about it, some of it very recent.

 

[zago]

Everyone had it at some point. Search the forum, there is a lot of info about it, some of it very recent.

Sorry mate but there is no recent posts on this one. I have looked already before posting.

 

[Riba]

I just replied to one yesterday, here you go, for petrol though, but there are a few for diesel too:

Fault code P0401 & P0106

Hi, The amber engine light came on a while back and displayed fault code P0401 - EGR flow insufficient. I reset it and it came back on after a short drive. I scanned it again and also got fault code P0106 Map/Baro CKT range/performance. Just wondering what the best course of action is?

www.a2oc.net

 

[Riba]

Here is info for TDI:

https://www.a2oc.net/community/index.php?threads/disconnect-cowl-panel-grille-fresh-air-duct-without-removing-wiper-and-washer-jets-it’s-vital-to-remove-fresh-air-duct-to-get-access-to-back-side.36107/

 

[audifan]

If it is a BHC or ATL then the issue with the ASV is either it has filled the control box with engine oil, the gear teeth are damaged or it needs a software upgrade to increase the tolerances.

 

[zago]

If it is a BHC or ATL then the issue with the ASV is either it has filled the control box with engine oil, the gear teeth are damaged or it needs a software upgrade to increase the tolerances.

Thanks. The car was recently repaired. There was no pressure and technician told me that egr was leaking. After starting use the car this fault came. MIL lamp sometimes off sometimes on, strange. The car drives normally.

 

[zago]

Replaced this valves box but the result is the same

 

[zago]

Additionally looked at the basic settings 04. Parameters in 3 zone not so different as should be