Little Dog
A2OC Donor
I just pull 90 degrees by eye. I get it close enough. I thought the iPhone was quite novel though.
Undecided on gasket thickness. Not sure about the shells so not yet decided if going new, what I have or the shells from the engine in the car. Once I build up the engine Ill measure the protrusion and decide on the gasket. All I have done since I last posted is clean up. Going to get an engine re-manufacturers opinion on the bore glazing / honing.
I have not yet stripped down the head. Hoping the valve guides will be good so there will be no need for machining.
Undecided on gasket thickness. Not sure about the shells so not yet decided if going new, what I have or the shells from the engine in the car. Once I build up the engine Ill measure the protrusion and decide on the gasket. All I have done since I last posted is clean up. Going to get an engine re-manufacturers opinion on the bore glazing / honing.
I have not yet stripped down the head. Hoping the valve guides will be good so there will be no need for machining.