fbi
Member
I had a RNS-D as standard, but have retrofitted a RNS-E.
I have no information displayed in my DIS. After doing some research, mainly on A4 and A6 forums, I found the solution (I hope so!). The problem is the TMX box, since it acts also as a gateway to display information in the DIS using CAN BUS. The RNS-E does it itself. I have to bypass the TMC module (bridge antenna wires, and CAN wires aswell).
So, the question is : where is the TMC box in the A2 ?
I found something about the A-pillar on the German forum...
Thanks in advance
I have no information displayed in my DIS. After doing some research, mainly on A4 and A6 forums, I found the solution (I hope so!). The problem is the TMX box, since it acts also as a gateway to display information in the DIS using CAN BUS. The RNS-E does it itself. I have to bypass the TMC module (bridge antenna wires, and CAN wires aswell).
So, the question is : where is the TMC box in the A2 ?
I found something about the A-pillar on the German forum...
Thanks in advance