Hello,
I need help, I have a 3L that was working more or less OK, meaning without problems but not super smooth - no setting was done since a wild (maybe since the gearbox have been changed 100.000 kms ago).
So I adjust the clutch, very easy, from 1.81V to 1.93V
Then I just wanted to do the creep point, but I read on Ross tech we should do the 3 operations one after the other; so I start the Basic Settings.
I use VCDS and here is the mistake I've done. Instead of typing "014" in "04 Basing Settings" I used the "plus" button until to arrive to 014.
The gear actuator was making all kind of noise so by panic I switch off the car.
Then I tried again, correctly this time to "014", but it shows "RTFM!", I moved the liver and of course this put a mess in the settings and it all went wrong.
I manage to check the clutch again by opening the accumulator to release pressure, and it's still 1.93, but otherwise, what ever I do, it remain about 4V and the car wont start.
The errors I have are "00844 Switch for selector lever gate recognition -F257-" & "00846 Switch for selector lever Stop-recognition -F259-", this last one does not appears any more, just the 00844.
I check the value block 022, and indeed when I move the liver it does not recognize correctly all the positions.
There is no way the liver have "just now" connections issues, is there a way I can re-program correctly the liver ?
What should I do to restart the basic setting from the bottom ?
Thank you very much !