Hi all
I’ve just bought the 0.659 gears from Dan B in his recent ad. I have read the full 49 pages of this thread (well scanned a lot of it as I lost the will half way through) and I noticed one post from Mike (Skipton) as follows
“there are 2 additional parts needed, which add another £2.50 to the costs!!!
It's the dished washers that secure the 2 cogs and the originals are too big after the swap and would foul in the teeth.
The needle roller bearing that holds the synchro gear. It's necessary to heat up the gear to remove it from the shaft and as the cage from the bearing is made from nylon, this could get damaged.”
Can anyone shed any light on the above two items i.e any part numbers or further information so that I can obtain the parts before attempting to have them fitted.
Many thanks
Steve