Howey
Member
Excuse my ignorance if this is a silly questionGuys, apologies, as seat bracket manufacture hasn't gone to plan.
Soooo here are details of what I fabricated. All from 40 x 8mm steel, as I wanted drilled and tapped brackets rather than using thinner material with nuts.
Note. My seats were offset towards the doors, ie directly over the door side runners, which offsets the seat from the steering wheel. It never bothered me, but I think if offset towards the centre console, then the complex rear bracket would become just a spacer plate and the opposite rear bracket becomes an offset plate.
You will need one off each of the 4 brackets per seat. Just be careful about handing left or right with the fabrications.
Hope this makes sense, but if not, ask away!
Sent from my SM-N960F using Tapatalk
Do your seats on the front mounting bolt thru the runners in to your bracket (with threaded hole and 9mm hole drilled in bodywork to allow clearance for said bolt) opposed to at the end of rail where they would have done so on the tt factory fit?
Cheers
Howey